Pro'sKit SS-331H LCD Electric Desoldering Gun Anti-static High Power Strong

Description

Pro'sKit SS-331H LCD Electric Desoldering Gun Anti-static High Power Strong.
Describe:
Pro'sKit made a comprehensive upgrade for the explosive product SS-331H. After upgrading, the function and performance of the product were effectively improved.
The effect is doubled, and the automatic sleep function is added to effectively improve the service life.
Model No:SS-331H
Voltage: 220 V-240 V~ 50 Hz
Soldering Power: 90 W
Power Consumption: 140 W
Temperature:160 deg C ~ 480 deg C
Vacuum Pressure:>600 mm Hg
Heating Element:Ceramic Heater
USE Notice:
1.After Each Use. It is Recommended to take 3-5 times of Empty Suction to Full Clear the residual Tin in The Tube.
2.If the interval is about 20 minutes, it is recommended to use a needle to clean the steel pipe after empty suction.
3.During the use, If the suction is reduced. Please use a needle to clean the steel pipe.
4.If you do not use often, it is recommended to adjust the tin gun to about 200 degrees, and then adjust to the working temperature when using it
5.When there is about 1/2 of the tin slag in tin storage. It should be cleaned in time. When the filter Spong is hardness,Pls replaced in time.
6.The Reason For Block Desoldering Gun
1)The temperature is set too low for long time desoldering,  The solder Tin does not reach the storage tube,But the  temperature comes down.So they  Stayed in the  tube,Make    it  Block
2)Did not clean in time when too much tin slag in the tin storage tube , This will effect the Gun's suction , In  this case , you should remove tail's tin slag . it can be removed only after you use the soldering iron to heat the tin until it melt